Module spare parts DSAI130 57120001-P5

Product Details

Product Description

Product Description
Focus on DCS, PLC, robot control system and large servo system.
Main products: various modules / cards, controllers, touch screens, servo drivers.
Advantages: supply of imported original products, professional production parts,
Fast delivery, accurate delivery time,
The main brands include ABB Bailey, Ge / fuanc, Foxboro, Invensys Triconex, Bently, A-B Rockwell, Emerson, ovation, Motorola, xyvom, Honeywell, Rexroth, KUKA, Ni, Deif, Yokogawa, Woodward, Ryan, Schneider, Yaskawa, Moog, prosoft and other brands

DSAI130 57120001-P5

Installing the Shelf into the Rack To install an STK‐RPS‐150CH2 or STK‐RPS‐150CH8 into a 19‐inch (48.3‐cm) rack, you need the following: • For the STK‐RPS‐150CH2: four customer‐supplied screws to fasten the shelf to the rack rails • For the STK‐RPS‐150CH8: ten customer‐supplied screws to fasten the shelf to the rack rails After installing the power supplies as described in “Installing an STK‐RPS‐150PS Into a Shelf” on page 2‐11, rack mount the chassis as follows: 1. Refer to the installation guidelines (“Guidelines for Rackmount Installation” on page 2‐14). 2. Install the chassis into the rack (“Rack Mounting the Chassis” on page 2‐15). 3. Connect the RPS cables and AC power cords of the power supplies (“Connecting the RPS Cable and AC Power Cord” on page 2‐16). Guidelines for Rackmount Installation The installation site must be within reach of the network cabling and meet the requirements listed below: • Shelf placement must be close enough to connect the 2‐meter (6.6‐foot) AC power cords from the power supplies to the AC power source. • Up to two three‐pronged power receptacles capable of delivering the current and voltage specified in “STK‐RPS‐150PS Specifications” on page A‐4. Up to two AC outlets on independently‐fused circuits must be within 182 centimeters (6 feet) from the installation site. If there is an AC power source failure, this will prevent the powering down of PSMs due to a single source power failure. • Power cords and type of outlet are dependent on the country. In the United States, one power cord with an NEMA 5‐15P plug is provided with each STK‐RPS‐150PS. • An ambient temperature of between 0°C (32°F) and 50°C (122°F) must be maintained at the installation site with fluctuations of less than 10°C (18°F) per hour. Caution: To ensure proper ventilation and prevent overheating, leave a minimum clearance space of 10.16 cm (4.0 in.) at the front and rear of the A4 chassis. Precaución: Para asegurar una buena ventilación y evitar que el sistema se sobrecaliente, deje un espacio mínimo de 10.16 cm (4 pulgadas.) con respecto a la parte delantera y trasera del chasis A4. Warning: Before installing the chassis into a rack, ensure that the rack can support the device(s) without compromising the stability of the rack. Otherwise, personal injury and/or equipment damage may result. Advertencia: Antes de instalar el chassis en un rack, asegurarse que el rack puede soportar el(los) dispositivo(s) sin comprometer la estabilidad del mismo. De otra forma puede suceder algun tipo de daño personal o del equipo. Warnhinweis: Schützen Sie sich vor Verletzungen und Geräteschaden, überzeugen Sie sich vor der Installation des Chassis in das Rack, von dessen Stabilitätates are not required.