Orthopedic Fiberglass Casting Tape Bandage Cast Casting Bandage

Product Description

Orthopedic plaster fiberglass Casting Tape

Products Name	Products Discription	Net Weight	Gross Weight	MOQ	Packing	Ctn Size
Fiberglass & Polyester Bandage	5cm*3.6m	14	16	1000	10pcs/bag,120pcs/ctn	62*39*40
	7.5cm*3.6m	20	22	1000	10pcs/bag,120pcs/ctn	62*39*40
	10cm*3.6m	19	21	1000	10pcs/bag,90pcs/ctn	62*39*40
	12.5cm*3.6m	23	25	1000	10pcs/bag,90pcs/ctn	62*39*40
	15cm*3.6m	27	29	1000	10pcs/bag,90pcs/ctn	62*39*40

Outstanding Advantages:
Excellent X-Ray Radiolucency
Good air-permeability
High strength and light weight
Environmental friendly material
Easy Operationn and Remove
Remove generate lower dust than plaster cast

Features:
Comparing with plaster splint, Its salient features are "light-weight,high-strength,excellent air-permeability and X-ray permissibility,easy-operation,environmental protection,etc.

1. Easy-operation. Follow general procedure. If Skin trauma occurred of the affected body part or the operation time is too long,please fix it, then spray water onto the package to accelerate hardening

2. Short cure time. Cured after molding in 2 or 3 minutes, and able to bear the weight after 10 minutes.

3. Stable molding. Good bending and tensile strength,Allow free bending. Cast could be made as tube-like splint and won't deform after cure.

4. Good hardness and orthopedic ability. Test shows that the cured Cast is 20 times harder than plaster,ensures the success of the surgery.

5. Good transmittancy. Clear X-ray effect ensures an accurate command of bone set and recovery conditions for doctors. Avoid affecting review due to insufficient light from plaster so as to reduce the risk of a second surgery.

6. Wide range of application. Bone fixation,orthopedic sursery, assisting walk during the sequela of apoplexy rehabilitation period, auxiliary function for artificial limb,protective support for burn wound.

7. Various Specification can use for different injury part, multicolor is used for different ages.

8. Environmental Protection. Cast and Splint can be burned without pollution.

Instructions:
Wind up a protective pad on the bone-wound part first.
Open the package with gloves.Immerse the casting tape into water at room temperature for 5-8 seconds.Squeeze out excess water.
Wind the casting tape onto the protective pad layer by layer,overlapping half width of every casting tape layer.Then press gently for intimate contact and proper shaping.It will be harden and set in 5-7 minutes.
Bandage Removal:cutting by an electric plaster saw.