Laboratory Consumable ABS Material 25/100-Place Foam/Cork Lining Microscope Slides Storage Boxes

Product Description

25 place 100 place foam cork slide storage boxes
Features: · Made of strong ABS material · Available in 25-place or 100-place sizes · Traditional cork or foam lining available · 5 assorted colors available: red, yellow, green, blue, and white · Store 25mm × 75mm microscope slides · Each slot is numbered to correspond to the slide inventory sheet inside the lid · 100-place slide boxes are secured with a rust-resistant clasp and hinge pin
Ordering Information:

Cat #	Place	Lining	Color	Sterile	Unit
41-5025	25-place	Foam	Assorted	NO	20 Pieces/Case
41-6025	25-place	Cork	Assorted	NO	20 Pieces/Case
41-5100	100-place	Foam	Assorted	NO	30 Pieces/Case
41-6100	100-place	Cork	Assorted	NO	30 Pieces/Case

1. What are the main factors that influence the maximum centrifugal acceleration force? Use of organic solutions, temperature below 0°C, centrifuging without centrifuge adapter, etc. Conduct a trial run to determine proper conditions before any critical use begins.
The RCF (relative centrifugal force) or G ratings for our disposable centrifuge tubes have been established at room temperature using tubes filled to nominal capacity with water and centrifuging for 30 minutes. recommended carriers, adapters, and cushions that fully support the tubes. If an angle head rotor is used or proper support is not provided, G values will be lower.
Do not confuse speed or revolutions per minute (RPM) with relative centrifugal force (RCF). Instructions for centrifuging a sample at a given RPM and time are incomplete unless the rotor or radius is specified. Protocols should always state the time and RCF value for centrifuging a sample.

2. What are autoclaving guidelines of plastics?
To ensure successful steam sterilization of your plastic labware please adhere to the following guidelines: PLEASE NOTE THAT NOT ALL PRODUCTS ARE AUTOCLAVABLE. Autoclave plastic consumables at 121°C and 15psi/1 atm for 15 minutes. Do not use a dry cycle, as this may cause deformation or weakening of the plastic. Allow temperature within the autoclave to return to 80°C or below before removing products.

3. What are Biologix's Commitments to Quality?
At Biologix, we look at quality from every angle in terms of functionality, safety, purity, formulation, consistency, manufacturing, customer service, technical support, and much more, all in order to consistently ensure customer satisfaction. According to the detailed QA/QC procedures for our manufacturing facility, each and every product is traceable by lot, regardless of packaging format. Products must go through a five-step human inspection before being released for packaging. Our facility is equipped with the latest instruments and technology from the most trusted manufacturers, ensuring that Biologix applies the most stringent standards to certify that products are free from RNase, DNase, endotoxin (pyrogens), etc.