Ham Radio Polices Scanner CB Antenna

Product Description

Ham Radio Polices Scanner CB Antenna Specification:
1.28 inch cable let you can put the antenna to the best position with good signal.
2.FULL KIT - includes strong magnectic sucker with 197 inch of coaxial cable, coil load, and stainless steel whip.
3.Strong magnetic sucker - Improve reception by harnessing large metal surfaces.
4.Heavy Duty Magnetic Mount - Note the antenna must be magnetically mounted for the best performance and lowest SWR
5.Easy to install on the roof or trunk of any vehicle and enjoy quality signal reception.
6.The ulimate recreational magnet mount antenna - ideal for trucks, SUVs, and recreational vehicles this antenna will stay on when you need it, but is completely removable when not in use.
7.Warranty would be valid for 12 months against manufacturing defect.
Cb radio antenna description:

Uniden: BEARCAT 880 CMX760 PC78LTX PC787

Cobra: 29LX 29LTD 29NW

Miland: 75-822 5001Z 1001LWX

Galaxy: DX-959B DX-949

President: McKinley USA ect

Magnetic mount

Center coil-loaded heavy duty spring

2 sections

Cable: 197 inch (5M)

Extends to 28 inch(0.7m)

Magnetic base: 88mm

Impedance: 50Ω

Frequency: 27Mhz

Installing
1.Please connet antenna to included magnetic base. This will be mounted,preferable,on the middle of your car roof.
2.After antenna is connected block it with included blocking key.
3.A calibration is not required for this antenna . This is made by factory of only on particularly cases to get an optimal SWR value you will need to extend or to cut your antenna wire.
Packaging:
1*Magnetic base with 197 inch of cable
1*Center coil-loaded heavy duty spring
1*stainless steel whip
Warning! Observe the maximum height on roads where will drive so that the antenna does not touch any installations or construction.